JXZ0818/2
type gantry moving type double spindle set box of high-speed CNC tube sheet and
baffle stack drilling machine is mainly used for boiler industry set header
pipe drilling and welding processing of basin shaped hole. Can use twist drill
can be used in cold hard alloy cutting tools for high speed drilling
processing, no need manual scribing and improve the position precision of the
holes and drilling efficiency, realizing the automation of drilling.
Use procedures and precautions:
1.
It is strictly prohibited in high speed
CNC header drilling and welding operation (if the welding work is needed in the
maintenance and need to disconnect the servo line before the operation).
2.
due to equipment for high speed drilling
machine, is strictly prohibited in the unattended operation, operation
personnel should remain in operation platform, in order to observe the
processing condition. If main, auxiliary processing at the same time, each side
of the table are should be operating personnel guard (and equipment operation
irrelevant personnel prohibited within the range of move devices to stay to
watch).
3.
Operator of the numerical control set
box drilling machine is strictly prohibited to wear gloves operating equipment.
4.
To promptly clean up the iron inside the
machine, especially the V-shaped slide rails on both sides of the part, if too
much, will affect the recycling of cutting fluid, and caused a built-up edge
leakage.
5.
Check the level of hydraulic pressure
station before boot, if the liquid level is too low, it should be timely to add
hydraulic oil, and check whether the equipment has hydraulic oil leakage.
6.
Check the oil level automatic
lubricating pump, if too low to replenish.
7.
Check the level of the cooling water
tank before boot, if the liquid level is too low, add the cooling water and
cutting fluid in time.
8.
When the power is switched on, the power
supply is in the order: first, open the cabinet main switch, and then open the
system key to control the power supply.
9.
No matter what kind of work, be sure to
start the hydraulic unit in the header of a drilling machine side (auxiliary
side start hydraulic function).
10. Hydraulic
system, cooling system and chip removal system must be started before the
automatic operation of CNC high speed drilling machine.
11. If
the move V support, you need to quickly plug the hydraulic connector loose,
move to the target position to connect the corresponding fast plug, the plug is
absolutely not allowed to dock errors, can refer to the non move stent. After
the completion of the move and rotation test for supporting a shaft is in the a
axis rotation rise jointly rotating end common fall. If not, the corresponding
plug swap.
12. If
the NC high speed set box drilling machine system, the reference point is lost,
the system does not allow automatic operation, the missing reference point of
the shaft back to the parameter, the return to the parameters are as follows:
13. X
axis: the move chuck to rear limit position, back to the parameters of the
model, "X", the X axis will automatically back to the reference
process (back to the reference before can be in manual mode will be the X axis
moved to close to the reference point, can be saved back to time reference,
because back to the reference is slow)
14. Z
axis: in the return mode, the point on the "Z", the Z axis will
automatically complete the return process;
15. A
shaft: because a axis configuration for absolute value encoder, in machine tool
debugging after need not return to the reference, if there are special
circumstances, chuck lock tight side holes are aligned automatically lock the
bolt tightening device, open a shaft parameters will P34210 is set to 1, back
to the parameters of the model, "a positive turn, back to participate.
Build
a working program, must be under the MDA inspection within the range of the
rotation angle of the minimum margins hole whether and the chuck claw conflict.
Drilling subroutine in borehole completion retracted position must be higher
than the minimum margin hole chuck claw height and preventing chuck rotation of
the tool spindle damage.
More
info. Please contact:
Jinan
Supertime Technology Co., Ltd.
Geat Machine.
回复删除