Supertime
engineer department
CJ100 CNC hydraulic punching machine is mainly used for
power transmission tower, communication towers or steel structure processing
connection board processing, and other machinery industry of plate material,
punching and marking.
1.
Computer operation of hydraulic punching
machine
Use the knob switch on the panel of the electric cabinet
to adjust the board. Other operations, such as: parameter setting, workpiece
programming must be carried out on the host computer.
2. Main screen of
computer operation
The total power, and then the key to open the host
computer front cover, then press the power switch, computer starts to enter the
WindowsXP operating interface, move the mouse to the new machine icon, double
left click into machine control program of main operation picture, as shown
below.
(1)Machine top view
(2)Main menu
Including: machine parameters ; NC module parameters;
work piece program; ready state; real-time monitoring; DXF data interface;
program management; ERP login; ERP database password management; end.
(3)Current address
When the digital display is gray, it indicates that the
shaft is not back to the reference point, and the black indicates that it has
been returned to the reference.
(4)Program run time target address (target program)
(5)Green: location module is normal; yellow: location
module warning; red: location module fault.
(6)Green: servo normal; red: servo fault.
(7)Click here to perform the axis reference, if you want
to make two and back to the reference point, can use the button operation. If
the boot after power did not perform reference return, display the current
address of the dark green.
To start after ginseng, servo motor first to "back
to the reference speed" to the negative direction (coordinate decreases)
mobile, when encountered reference point switch turn to slow continues to run
until he found a position feedback encoder Z pulse or fixed mobile travel is
determined by the back way to participate in, this system will be the current
coordinate is set to "reference point", the screen on the axis
display becomes bright green, back to the reference is completed.
Warning: if the action is not carried out, the
coordinates of the corresponding axis are not determined. At this point, the
soft limit parameters of the shaft can not be protected.
(8)Die position switch from left to right respectively 1,
die 1, 2 and 3, which represents 4 matrix; if 1 number display green, said no.
1 mold is in the punching cylinder is below.
(9)Punch, the lower limit switch is displayed as a green
time switch.
(10)Y axis limit switch in vertical direction from top to
bottom respectively after the limit; reference point; the limit.
(11)The horizontal direction of the X axis limit switch
is from the right to the left.
(12)Workpiece graphics Preview
3
. Hydraulic punching machine parameter
setting
Parameter settings including machine and numerical control
module parameters, parameter content existing installation directory under the
BJPARA.DAT file. When the machine commissioning and normal operation, clear the backup of this file, parameter to
prevent loss.
More info. Please contact:
Jinan Supertime Technology Co., Ltd.
没有评论:
发表评论