Fault info. Meaning of CNC Plate punching Machine (1)

Supertime Engineers Department

The most basic information about the fault information of CNC hydraulic punching machine.

1, 3, 4, 5 system failure, please check if there is interference and hardware errors.

:51 beyond the scope of the location, please re set the location within the specified parameter range, or modify the parameters.

:52  speed limit, please re set the positioning speed in the specified parameter range.

:100 run external device to stop, please press the reset button to clear the error.

:101 run READY PC signal is broken, please press the reset button to clear the error.

:102 in the running of the servo ready signal is disconnected, please press the reset button to clear the error.

:103 run in the test error, please A1SD75 positioning module and external device power disconnected.

:104 the machine before the limit switch alarm, please press the reset button to clear the error, and then in the manual mode to reverse the operation of the motor.

:105 after the machine is limited to the alarm, please press the reset button to clear the error, and then in the manual mode to reverse the operation of the motor.

:106 when the signal is switched on, press the reset button to clear the error.

:107 busy when the READY signal is switched on, the next operation will not be able to start, the PCREADY signal (Y1D) from the disconnect to the switch, that is, the power up.

:201 starting at the reference point, please enable the return to retry function, or manually move the current position after the return of the action.

:203 reference point switch error, please modify the return speed.

:204 Z pulse signal indicates that the time is wrong, please modify the return speed.

:205 stop time error, please modify the speed of return.

:206 counting back way to participate in a feeding error, please by speed limit, back to the reference speed and deceleration rate to calculate feeding distance, set to a value greater than or equal deceleration distance; reduced back to the reference speed; adjusting the reference point switch position or extend the touch switch after the feeding value.

:207 return to the request sign on, please perform the return to action.

:208 out of the range of crawling speed, please set the crawl speed in the speed range.

:209 parameters and then start is invalid, please re start back to the action.

:300 beyond the range of manual speed, please reset the manual speed (not zero) within the set range.

:500 location condition data error, please reset the special starting data.

:501 error before the start of the synchronization, please reset the special starting data.

:502: the starting date is incorrect. Please modify the location data.

:503 did not set the positioning speed, please modify the machine parameters.

:504 out of the linear range, please check the location address.

:506 circular interpolation error, please modify the center address and destination address; in the circular interpolation allows error range changes within the set value.

:507 start time is beyond the soft limit, please use the manual method to move the current position to the soft limit range.

:508: after starting the soft limit limit, please use the manual method to move the current position to the soft limit range.

:509 stroke beyond the soft limit of limit, if it is running and positioning, please set the address location in the soft limit range; if manually. Please run in the soft limit range; if the execution has not been too back to the reference point, please back to perform action.

:510 travel beyond the limit of the soft limit, if it is running and positioning, please set the address location in the soft limit range; if manually. Please run in the soft limit range; if the execution has not been too back to the reference point, please back to perform action.

More info. Please contact with:

Jinan Supertime Technology Co., Ltd.

www.jntime.com