CNC hydraulic punching machine | Electric control operation

Supertime Engineer Department.

Instruction of control system operation

⑴    Button Control Station operation

Use the rotary switch of Electrical cabinet operation panel to adjust the Machine.

⑵ Panel Operation Introduction

All the operation buttons installed on the Electric cabinet panel except a Foot Switch and program initiator, program stop, hand-operate punching and scram button.

Function Introduction
1.Electric Source Operation Introduction
⑴ Main power switch, After insert the key to unlock, rotate the handle to the ON position, Flip the switch on, vice to rotating the handle to OFF, namely cut general power. Note, must keep the handle and air switch with the consistent position when close the electric cabinet door. Otherwise it will not be able to close the door.

⑵ Power source Close/Open key button is used for electric source of control circuit.

2. indicator light instruction

⑴ Power light, it indicates the power circuit is live when the key power switch is on.

⑵ Oil pump motor light indicates the pump is started.

⑶ fault indicating light shows that faults occur on servo motor, positioning module and machine. Click the corresponding fault position on the PC screen to know the details.

⑷ ready light, after ready light up the automatic system could launch, the conditions below：

① main punching cylinder, press cylinder, press cylinder back to the toplimit

② X,Y axes back to the reference point

③ dies are ready

④ on fault indicator light

⑤ materials are on the clamp

⑥ automatic state

3. button function:

⑴ pump start/stop button controls the motor of oil pump.

⑵ clamp on/off and pedal on/off, to infeed and outfeed the material. Before launch the automatic process the clamp must on and the position plate must reset.

⑶ emergency button, press the button during emergency, this function could shut down the power source of servo motor and oil pump. After removal of breakdown, release the button and start the oil pump again, press the break reset for 2 sec. to plug in the servo motor.

⑷ adjust/automatic switch is used to choose the adjust state and automatic state.

Only under the conditions blow can use these buttons below:

① X axis motor forward/back switch, switch to forward X axis(clamp) moves forward, release the switch then X axis stops moving, on the contrary it goes back.

② Y axis motor forward/back switch, it moves like the X axis to control the movement of Y axis(infeed table).

③ emergency reset, this button can release the alarm when emergency light on.

④ die selection, artificially choose die, one die changes at a time.

⑤ punching, used for artificial punching, after oil pump stopped press this button can release the oil pressure.

These buttons below can be used only under automatic state:

① machine start, after the machine is ready(ready light up),press this button with the indicating light, machine starts to process; when machine pauses the light flashes, press again to proceed the processing; after the program is over or stopped the machine, light off. Notice: before the automatic launch, please set the parameters correctly, and then transfer the work file, confirm the steps of the program and then press the launch button again.

② program stop, during the automatic processing, press once to pause the processing, X,Y axes stop immediately, but die changing and punching continue to its end; press twice, program stops. In addition, press the button during the artificial positioning will interrupt the axis positioning and back to  reference point.

More info. , please contact:

Jinan Supertime Technology Co., Ltd.

www.jntime.com